This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
New Chopper build
#1
Hello! I've been printing things for a few years now. I started on an Ultimaker 2 that I was soon figuring out how to get it to print.. after discovering the rods in the back were defective. After learning how to install the new ones I was soon doing mods to the print head to convert it to 1.75 from 3.0 and a new feeder. Fast forward a bit and I added a Creality 10-S4 to the production crew and fought with that for about a year until it was printing nicely. Seriously.. how do they expect a bed that size to heat evenly with the heater pad they put on them? 

I've wanted to print a Chopper for awhile now since Rebels came out but other projects have taken precedence for my printer's time. I finally got to a point where I could start him a few months back. I started on the body since that seemed the most logical point to build off of. The files are awesome and print out nicely. Now that I have all the parts for that I can start putting it together and move to printing another section. Definitely going to be a long build but it will be so worth it. Smile
Reply


Messages In This Thread
New Chopper build - by lrobar99 - 07-19-2021, 09:31 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)